Fujioh BUF-03R - Manual (Page 8)

8
INSTALLATION (continued)
In case of Horizontal Discharge
(1) Referring to Fig. at right, provide
a rectangular hole in the wall for
passing through the exhaust pipe.
(2) Remove the exhaust pipe from the
top of the range hood.
NOTE
Keep 4 screws (M4
× 8) for fixing the
exhaust pipe later.
(3) Detach the cover plate by removing 2
fixing screws, and attach it as shown
in Fig.
(4) Attach the range hood to the liner.
Refer to page 9 for details.
(5) Connect the exhaust pipe with the
duct, then make the duct joint secure
and air tight using non-flammable
tape such as duct tape, etc. (not
supplied)
(6) Attach the exhaust pipe to the range
hood with 4 screws (M4 ×8) , from out
side of the wall.
(7) Connect the duct to out side wall cap.
(not supplied)
CAUTION
To prevent air or moisture from entering through the wall opening, be sure to install
wall insulation to seal around duct work completely.