Frye FONIX FP40D - Manual (Page 26)

18 FONIX FP40 Portable Hearing Aid Analyzer
2.2.1 Making selections
Notice the three columns in the General Setup Menu. Move the selection indicator (lines above
and below the selection) from one column to another using the FREQUENCY knob. Move the knob
slowly. You will feel each position change. Move the selection indicator up and down within the col-
umns with the AMPLITUDE knob.
Push the START/STOP button, found in the very center of the front panel, to switch between the
available choices at the indicated position.
2.2.2 Saving changes
Unless you purposely make setup changes permanent, they will only be effective until you turn off
the analyzer. When the analyzer is turned on again, it will revert to default settings. However, you
can change the default settings to suit your own needs.
• To change the default setting of an individual item, highlight the item in the General Setup
Menu, change it to the desired setting, and press F8. This will store the individual item set-
ting.
• To set the default settings of the entire menu at once, make any desired changes in the
General Setup Menu, and press F9. This will store the entire menu.
2.2.3 Switching between partial and full menus
Not all the items in the General Setup Menu will apply to every screen of the FP40. In order to
avoid information overload, the FP40 has a “Partial Menu” mode.
If the FP40 is in PARTIAL Menu mode, it will only display the items of interest to the screen you
just left. For instance, if you enter the General Setup Menu from the Main Coupler Screen, the par-
tial menu will not display Probe Settings. Also, if you have selected a composite signal source, it
will not display the pure-tone settings.
When the FP40 is in FULL Menu mode, it will display all available settings, regardless of the screen
that you just left or the signal source you have chosen.
To switch between Partial Menu mode and Full Menu mode, select MENU TYPE in the General
Setup Menu. Choose between FULL and PARTIAL.