Foundry Networks AR1202 - Manual (Page 20)

Foundry AR-Series AR1202 and AR1204 Installation Guide
3 - 2 © 2004 Foundry Networks, Inc. June 2004
Power Requirements
The AR1202 and AR1204 router operates on 12 VDC power. A 12 VDC power supply and an AC power cord are
shipped with the router.
Network Connection
To successfully complete the installation, the router must be connected to a network. Before you start the
installation, make sure that a live network connection is available at the installation site.
Cables Required
The AR1202 and AR1204 router ships with a Console cable. You will need to obtain additional cables for your
specific application. The following additional cables are required to install the AR1202 and AR1204 router.
• One or two RJ-45, male/male, category 5, 26 AWG (minimum), twisted-pair, straight-through cable (Ethernet
LAN connection)
See Table A.8 on page A-6 for cable pinout information.
Refer to Figure 3.2 on page 3-2 to identify this cable.
Figure 3.2 Ethernet Cable
• One or two RJ-48C, male/male, category 5, 26 AWG (minimum), twisted-pair, straight-through WAN cable
See Table A.9 on page A-6 for cable pinout information.
Refer to Figure 3.3 to identify this cable.
Figure 3.3 WAN Cable
Tools Required
The following tools are required to install the Foundry AR1202 and AR1204 router.
Figure 3.4 Required Tools
#2 Phillips screwdriver #3 Phillips screwdriver 1/4 inch flat blade screwdriver