Foundry Networks AR1202 - Manual (Page 39)

Configuration
June 2004 © 2004 Foundry Networks, Inc. 4 - 11
The following text is output to the terminal:
10. To keep this parameter, press the Enter key.
The following text is output to the terminal:
11. Enter the path-qualified file name: type /tftpdir/r4.6/AR01_#### (or whatever is consistent with the file
download command in the above example) and press the Enter key.
The following text is output to the terminal:
12. Input the address for the Foundry system to use as an tftp client to the tftp host. Type 111.2.3.3:ffffff00 (or
whatever is appropriate for your network configuration) and press the Enter key.
Note that the netmask is specified in hexadecimal after a colon (here a 24-bit netmask). You must be in the
same subnet as the tftp host or the same subnet as the default router through which you will access the tftp
host.
The following text is output to the terminal:
13. Press the Enter key. The following text is output to the terminal:
14. At this point, the tftp host address must be entered. Type 192.168.10.1 (or whatever is consistent with the
downloadNCM command in the above example) and press the Enter key.
The following text is output to the terminal:
15. If a gateway does not exist between the Foundry router and the tftp server, then this can be left blank.
However, it is required if the router and the tftp server reside in different subnets. For this example you would
enter 111.2.3.254.
The following text is output to the terminal:
16. Make sure to type wind. Then set the password also to wind. Press the Enter key.
The following text is output to the terminal:
17. Set the flags. Type 0x8a. Press the Enter key.
host name : host
file name : /flash1/T2000.Z
1net on ethernet [e] : 10.1.0.1:fff0000
1net on backplane [b] :
host 1net [h] : 10.11.12.13
gateway 1net [g] : 10.11.12.13
user [u] : wind
ftp password [pw] [blank = use rsh] : wind