Foundry Networks AR1202 - Manual (Page 33)

Configuration
June 2004 © 2004 Foundry Networks, Inc. 4 - 5
Table 4.1: Default Configuration Values
Parameter Default
speed auto (negotiates 10 Mbps or 100 Mbps)
address uses the current address stored in the system.cfg file (if one exists),
otherwise an IP address must be configured from the command line
interface
duplex auto (negotiates half-duplex or full-duplex)
Table 4.2: Default IP Routing Settings
Parameter Default
IP routing 1 disabled
IP multiplexing
2
enabled
1, 2 IP routing and IP multiplexing are mutually exclusive of each other. Only one
can be enabled at a time.
Table 4.3: Default Telecommunications Values
Parameter Default Value Optional Values
framing esf d4
linecode b8zs ami
clock_source internal line
linemode csu dsx
lbo 0 dB 7.5 db
15 db
22.5 db
cable length 1 (0 - 110 ft.) 2 (110 - 220 ft.)
3 (220 - 330 ft.)
4 (330 - 440 ft.)
5 (440 - 550 ft.)
6 (550 - 660 ft.)
fdl ANSI and ATT unit protocol
enabled ANSI (only)
ATT (only)
yellow_alarm disabled generate
detect
generate and detect