Frymaster YPF95 - Manual (Page 18)

YPF95 SERIES PORTABLE FILTRATION SYSTEMS
CHAPTER 5: PREVENTATIVE MAINTENANCE
5-2
5.3 Daily: Close Of Business
At the close of a working day, filter the oil in all fryers. When the last fryer is finished, follow these
steps:
1. Ensure the flexible hose and pump lines are clear by running the filter pump for an
additional 10–15 seconds after the faucet begins to bubble.
2. Discard the filter paper in a fireproof container after use.
3. Remove the filter pan cover and hold-down ring assembly, and then remove the filter paper
and Sana Grid.
4. Wash all filter components with soapy water and rinse.
5. Dry all filter parts and the filter pan thoroughly before reassembling.
6. Check all fittings on the filter unit and ensure that they are properly tightened.
DANGER
The crumb tray (if applicable) in portable filter systems must be emptied into a
fireproof container at the end of frying operations each day. Some food particles
can spontaneously combust if left soaking in certain shortening material.
5.4 Weekly
Follow the same procedure as for "Daily", with these additional steps:
• Wash the filter pan with hot, soapy water and a brush. Dry and reassemble with new filter
paper.
• Clean thoroughly under, around, and behind the fryers and filtering area.
• Do not operate motor/pump until all traces of water have been removed from the pan.
Under no circumstances should water or boil-out solution be allowed to enter the pump
housing; irreparable damage will result, and all warranties will be voided.
• Check the connections of the inlet lines and tighten if lines become loose or start to leak oil.