Foundry Networks M2404F - Manual (Page 11)

Foundry NetIron M2404C/M2404F Metro Access Switches
January 2007 © 2007 Foundry Networks, Inc. 5
3. Gently insert the SFP tranceiver into the port until the module clicks into place. The module
is keyed to prevent incorrect insertion. See Figure 5 .
Important Note
When inserting an SFP tranceiver into ports marked 27 or 28, verify that the SFP is facing
upside -down (as shown in figure below). All other SFP ports on the switch face right-side up.
Figure 5: Inserting an SFP, upside-down, into the Enhanced GigE Slot
NetIron M2404C Front Panel Main Components
Component Description
For NetIron M2404C:
10/100baseTX Ports 24 RJ-45 sockets with 10/100 Mbps LAN speed auto sensing,
marked 1 to 24.
GigE Dual-Mode Ports Two dual-mode1000baseX interface (SFP) or 10/100/1000BaseT
(RJ45) marked 25 and 26.
Enhanced GigE Ports Two 1000baseX interface (SFP) marked 27 and 28. Please note
that the SFP transceivers are inserted into the slot, belly-down, as
shown in figure above.
Console Management
Port RJ45 socket for CLI configuration and management of the unit.
Ethernet Management
Port RJ45 socket with 10/100 Mbps LAN speed auto sensing for out-
of-band Ethernet management and software update.
RST Button Reset button. To avoid accidental activation, the button is recessed
behind the panel. Press with a pin or a similar narrow object.
NetIron M2404F Front Panel Main Components
Component Description
For NetIron M2404F:
100baseX Ports 24 SFP sockets marked 1 to 24.