Furuno IF-NMEASC - Manual (Page 21)

5. MAINTENANCE, TROUBLESHOOTING
13
Self test 2
This test checks this unit's processor and output for proper operation.
1. With the display showing " - - - .1", push the [Menu/Cancel] button. The display shows "- - - 2".
2. Press the [Enter] button to start the test.
If the results are normal all LEDs light. Then, the nine LEDs below the display flash and the
display shows "End.2".
3. Press the [Enter] button to return to the self test 2 display.
5.5 Memory Clear
The memory can be cleared to restore the default settings for the NMEA ports. Note that offsets
are not cleared.
1. Hold down the [Menu/Cancel] button together with the [+] button until the display shows "-
CLR". At this time all Status and Settings LEDs are on.
2. Press the [Enter] button to clear the memory and restore all default settings. "END C" appears
upon completion.
3. After the memory is cleared, press the [Menu/Cancel] button to show the heading.
GPS OUTPUT PROCESSING
SENSOR1
SENSOR2
IF-NMEASC status
- + Enter
Menu/
Cancel
Self test 2 activated
Heading Pitch
Sentence
Roll
Bps
Output
Interval
Bps Sentence
Output
Interval
GPS OUTPUT PROCESSING
SENSOR1
SENSOR2
STATUS of IF-NMEASC
- + Enter
Menu/
Cancel
L R C
Heading Pitch
Sentence
Roll
Bps
Output
Interval
Bps Sentence
Output
Interval