FUJITSU fi-5000N - Manual (Page 21)

fi-5000N Getting Started
13
2.6 Registering Fingerprints
For user authentication, register each user’s fingerprint
information on this product. However, injured users and
users with difficulties in registering fingerprints can be
authenticated by using a PIN (personal identification
number).
Register users' fingerprints following the procedure
below.
1. Open the Cover.
2. Confirm that the "Place your finger on the sen-
sor" (this indicates the "Logout" status) is dis-
played on the fi-5000N Message Display. Then,
press the [SET] key.
The following screen appears.
3. Select "Register Finger", and press the [ENT]
key.
The list of registered users on fi-5000N appears.
4. Press the [K] or [L] key to select a user from the
list of registered users, and press the [ENT] key.
The following screen prompts you to enter the PIN of
the selected user.
5. Enter the PIN set in "Registering Users" (on
page 11), and press the [ENT] key.
If the PIN does not match, the message "The PIN is
incorrect" is displayed, and you are prompted to enter
again.
If the PIN matches, the following screen appears.
Confirm the correct finger placement by referring to
the sticker inside of the cover. For the details, please
refer to "Appendix 3 Using User Authentication By
Fingerprint.".
Press [ENT] key, then the following screen appears.
6. Place the finger to register on the fingerprint
sensor.
If your fingerprint is correctly captured, a buzzer
sounds and at the same time the following screen
appears.
ESC ES
C
I D I D
SET SE T
7
8
9
4
5
6
1
2
3
0
.
Setup
Register Finger
Change PIN Code
Show Network Config
Select User
1 (user's name)
2 (user's name)
3 (user's name)
HINT
You can also select the registered
user by entering user ID number:
1. With the keyboard, enter the user
ID number.
2. Press the [ENT] key.
⇒
The name of the user to log in will
appear selected.
3. Press the [ENT] key again.
PIN:_
Cancel:[ESC]
Look at the sticker
inside of cover for
finger placement
OK:[ENT]
Registration:
Place your finger
on the sensor
Processing...
Remove your finger
from the sensor