FUJITSU fi-5000N - Manual (Page 22)

14
7. Remove your finger from the fingerprint sensor.
The following screen appears, and the fingerprint
verifications will be repeated twice.
8. For verification procedure, place the finger to
register on the fingerprint sensor again.
If the verification is successfully done, the following
screen appears
9. Second verification starts.
10.When the second verification process has been
completed, the following message appears.
Then the message indicating that the fingerprint data
is being saved is displayed.
Next, the registration completed message appears.
Press [ENT] key to finish the registration.
2.7 Scan Test
Do an image scan test after configuration.
Scanning from fi-5000N
("Push" mode)
Check whether the image can be scanned successfully
using the below procedures.
• User Authentication
• Loading Document
• Scanning Operation when the scanner button is
pressed
■ User Authentication
To change from the logout status to the ready-to-start
scanning status, fingerprint authentication must be done.
Also, PIN authentication is equipped as an alternative to
an injured users or users with difficulties in fingerprint
authentication.
Authentication by Fingerprint
1. When "Place your finger on the sensor" mes-
sage is displayed, place the registered finger on
the fingerprint sensor.
When the finger placed on the fingerprint sensor is
detected, the following message appears and the fin-
gerprint capturing begins.
Fingerprint will
be verified twice.
Place your finger
on the sensor
First Verification
is successful
Starting Second
Verification.
Place your finger
on the sensor
Second Verification
is successful
Saving fingerprint
data...
Registration is
successful
OK:[ENT]
HINT
When you learn to place the finger
correct, you can remove the Finger
Guide. For the removal, refer to
"Appendix 3 Using User Authentica-
tion By Fingerprint."
Place your finger
on the sensor
fingerprint...
Capturing