FUJITSU Mainboard D1931 - Manual (Page 20)

Internal ports and connectors
10 - English A26361-D1931-Z120-1-7419, Edition 1
Graphics port
Technical data
Function:
2D/3D graphics controller, Dynamic Video memory Technology, 400 Mhz
integrated 24-bit RAMDAC
Features: Display Data Channel (DDC), 2 DVO channels (up to 165 megapixels per
channel), dual-view support for ADD2 boards
Screen resolution
Depending on the operating system used, the screen resolutions in the following table refer to the
mainboard screen controller.
If you are using an external screen controller, you will find details of supported screen resolutions in
the operating manual or technical manual supplied with the controller.
Screen resolution Refresh rate (Hz) Colour
640 x 480 120 32 bit
800 x 600 120 32 bit
1024 x 768 120 32 bit
1280 x 1024 120 32 bit
1600 x 1200 120 32 bit
1920 x 1440 85 32 bit
2048 x 1536 75 32 bit
Internal ports and connectors
The positions of the internal ports and connectors are shown on the Cover. Additional information on
some ports is also provided here.
Hard disk connection
An ultra ATA/66 or ultra ATA/100 hard disk must be connected with a cable especially designed for
the ultra ATA/66 or ultra ATA/100 mode.
►
Connect the end of the cable marked with blue to the mainboard.
A serial ATA/150 hard disk must be connected with a serial ATA cable.
►
Connect the cable to the hard disk and to the connector on the mainboard.
If you have connected hard disks to serial ATA (one hard disk is possible per serial ATA
connection), you must configure the respective settings in the BIOS Setup (further information you
can find in the BIOS Setup manual).