FUJITSU Mainboard D1931 - Manual (Page 42)

APM and ACPI system status, energy-saving modes
32 - English A26361-D1931-Z120-1-7419, Edition 1
The specifications apply to the onboard components and represent the least favourable case. In
addition, at least 350 mA is required for PCI on 3.3 V, and 500 mA per connected device for USB on
5 V.
APM and ACPI system status, energy-saving modes
System status ACPI
Status
) 1
APM
Status
Power
LED )
2
Power
LED )
3
Power
consum
ption
Wake-up
time
Normal operation G0 S0 On On/Off On Normal
Simple energy
saving mode
S1 Standby Off/On flashin
g
Almost
like
normal
Almost
immediate
ly
Maximum energy-
saving mode ) 4
"Save to DRAM"
S3 Off/On flashin
g
RAM,
wake-up
compone
nts
ca. 5s
Maximum energy-
saving mode **
"Save To Disk"
G1
S4 Off/Off Off RAM,
wake-up
compo-
nents
ca. 20s
”Soft Off" G2 S5 Soft Off Off/Off Off Nearly
zero
Full boot
time
Mechanically Off G3 Off Off/Off Off Zero Full boot
time
) 1 G = Global status; S = System status
) 2 Two colours
) 3 One colour
) 4 The power supply unit must provide sufficiently loadable 5 V standby voltage.
To use the WOL functionality the power supply must provide a 5 V auxiliary voltage (5VSB) of at
least 1 A.