Falcon SUP1.0K-1C - Manual (Page 13)

6. Battery Charging
This UPS is shipped from the factory with its batteries fully charged.
However, some charge may be lost due to the self discharge
characteristics of the internal sealed lead-acid battery. Always allow
the UPS to recharge for 24 hours prior to use. To recharge, simply
connect the UPS line cord to a powered receptacle. The UPS does
not have to be turned on for batteries to recharge. During normal
use, the UPS will self recharge should the battery be depleted due to
a loss of utility power.
7 UPS Reset
In the event the UPS will not accept commands and appears to be
locked up, depress the control button for and hold for ten seconds.
The UPS CPU will be reset.
8. Remote Control
The UPS can be set for an automatic daily shutdown and start up.
This command must be set through the RS-232 interface using the
supplied software. When this function is set, a timer inside the UPS
will begin to run.
The load will be turned off according to the shutdown and start up
schedule set in the software, which is then transferred and stored in
the UPS memory. During the period of turn off to the next turn
on, the status LCD "time entered" symbol will blink.
12