Falcon SUP1.0K-1C - Manual (Page 9)

6 Boost Mode - The AVR is increasing the UPS output voltage due to
a low utility voltage condition or "Brown-out". The
sinewave symbol is also displayed to indicate that the
UPS is operating normally from the utility line.
7. Timer is enabled - This symbol will be displayed during the following
conditions:
a) The UPS has been programmed to automatically turn
on or off using the supplied remote monitoring software.
b) The green mode is enabled and the UPS output load is
under 25 watts. The UPS will turn off after a 30 second
delay.
8. Over Temperature - The temperature inside the UPS has exceeded
55ºC. If the end-user does not reduce the UPS
output load or correct the cause of the UPS
overheating, the temperature will continue to
rise and upon reaching 60ºC the UPS will
shutdown to prevent damage due to excessive
overheating.
9. Fan off - This symbol is used on special extended backup models
only.
10. Alarm off - The audible alarm has been silenced. To reset the alarm
during backup mode, briefly depress the control button.
11. UPS fault - Attempt to perform a UPS reset by depressing the
control button and holding it for ten seconds. If the UPS
resets and operates normally, no further action is
required. If the UPS fault indicator is still displayed, the
UPS has failed and must be repaired.
12. Battery low - When the battery charge level is low, the word "LOW"
will be displayed inside the battery normal symbol.
13. Battery normal - During normal utility operating this symbol
indicates a charged battery.
14. Battery level - When the battery is fully charged, all five bar graph
segments will be dark. As the battery discharges, the
segments will disappear starting from the top
segment and end with the bottom segment.
8