Fujitsu Siemens Computers 19P2 - Manual (Page 28)

Colour monitor 19P2
20 - English A26361-K713-Z100-1-5E19
Tilting and turning area
5°
13°
45°
45°
The specified tilting area refers to the zero position of the monitor foot marked with an arrow.
Error handling
Should an error occur, first check the following points. If the distortion is still not eliminated, the
monitor should, if possible, be checked on another computer.
If you are unable to solve the problem, please inform our Help Desk.
The screen is blank (power indicator does not light)
Ê Check whether the monitor is switched on.
Ê Check whether the computer is switched on.
Ê Check whether the power cable on the monitor is connected correctly.
The screen is blank (power indicator lights)
Ê Check whether the computer is switched on.
Ê Check whether the data cable for the monitor is correctly attached to the monitor and the
monitor port on the computer.
Ê Check whether the monitor connection of the computer used is active.
Ê Press any key on the computer keyboard – the computer may be in energy saving mode.
Ê Change the brightness and/or the contrast; the monitor may be adjusted to the maximum dark
setting.
The screen display is too small or not centred
The monitor recognises an undefined mode (see " Technical data ").
Ê Set the picture size and position with the OSD menu (see " Operation of the monitor ").
Picture geometry is defective
Ê Set the picture geometry with the OSD menu (see " Operation of the monitor ").