Fisher PJ-Net - Manual (Page 91)

91
Network Unit
OWNER’S MANUAL
ENGLISH
Use of telnet
3
When communication is established, the word “PASSWORD:” appears on the
window. Type the login password* for the projector and then press “Enter” key on
the keyboard. If you do not register the login password, just press “Enter” key.
When the word “Hello” is replied, login has been succeeded.
4
Type the commands from the key board to control the external equipment and
then enter “Enter” key for termination. For example, type “C00” and enter
“Enter” key.
- The extra projector will be turned on.
* “C00” is a command to turn the projector on.
To disconnect the communication, type “Ctrl” key and “]” key at the same time.
* For example,
entering pass-
word [1234]
*1 Further instructions about the telnet application, please see the on-line guide on your com-
puter. Macintosh does not provide the telnet application.
*2 The commands are defined by each product independently, so please consult the manufac-
turer or sales dealer for further information of the commands.
* The password is a login password decided on page 20 or 30. If the authentication of the
entered password is failed 4 times continuously, the communication will be disconnected
automatically. Please try again for the connection.