Furuno 1832 - Manual (Page 31)

17
¡ range, bearing and time-to-go to both
waypoint selected on the navigator and the
cursor
¡ speed.
(If the navigation input includes destination
data, waypoint position is denoted on the ra-
dar display by a dashed ring.)
To turn navigation data on or off;
1. Press the [MENU] key.
2. Select the “DISP DATA”.
3. Press the [ACQ/ENTER] key.
4. Press the [ACQ/ENTER] key to select the
message for Navigation display.
5. Prss the [ACQ/ENTER] key to set.
6. Press the [MENU] key to close the menu.
“WATCHMAN” appears at the top of the
screen, the radar transmits for one minute to
check for targets inside the guard zone, and
then the CRT shuts off and the radar goes into
stand-by.
Cancelling watchman
Go into the “OTHERS” menu, and set “15.
Watchman” for off.
Note 1: Watchman can be used without a
guard zone.
Note 2: The alarm sounds just before the ra-
dar starts and stops transmitting.
3.9 Displaying Navigation Data
Navigation data can be displayed at the screen
bottom if this radar receives navigation input
in IEC 1162 format. Navigation data include
¡ position in latitude and longitude or Lo-
ran-C time difference
Figure 3-10 Typical navigation data display
HDG 234.5°
SP
HU
. 125
NM
.
0625
TRAIL
30M
ZOOM
ES1
AUTO
25:38
G (OUT)
VRM
0.048NM
0.100NM
13.5 R ° 0.142NM
A/C
AUTO
EBL
345.6 R
23.0 R
°
°
Waypoint Mark
Navigation
Data OWN SHIP
34° 56. 12N
135° 34. 56E
SPD 35.0KT WAYPOINT
0.
 NM
50.0°M
TTG 00:20
1.5 NM 0.06
+ CURSOR
34° 29. 98N
136° 35. 77E
TTG 01:00