10 other menu description – Furuno 1832 User Manual
Page 32
18
3.10 OTHER MENU Description
The following summarizes the OTHER MENU.
Table 3-2 OTHER MENU Description
Item
Description
1. Panel Dimmer
Select level of panel backlight.
2. Mark Brill
Select brilliance of VRM, EBL, cursor, guard zone and WP marks.
3. HD Mark
Select brilliance of heading mark.
4. Charactors
Select brilliance of charactors.
5. Trail Tone
Select brilliance of echo trails.
6. Int Reject
Select level of interference rejection.
7. Pulselength
Select pulselength for 1.5 and 3 mile ranges.
8. Noise Reject
Select “On” to reject noise.
9. Trail Time
Select the trail time.
10. Tune
Select automatic or manual tuning.
To tune manually;
1.
2.
3.
4.
Select “Menu” by the omnipad.
Press the [ENTER] key to enable manual tuning.
While pressing and holding down the [GAIN] control, operate
the omnipad.
Press the [ENTER] key.
“MANUAL” appears at the top right-hand corner when manual
tuning is in effect.
11. Disp Data
Select the down sourse to display.
12. WPT Mark
Select “On” to display the waypoint mark.
13. EBL Ref
select EBL reference for relative or true.
14. VRM Unit
Select distance unit of VRM and cursor for nm, km or sm.
15. Watchman
Turn watchman on (set rest period) or off.
16. STBY Disp
Select the display on stand-by; display “STBY” or navigation data,
or go into the economy mode.
17. Guard Mode
Select condition which triggers guard alarm; in or out.
18. Own Position
Display the cursor position in strength whitch trigger guard alarm.
19. Cursor Posi
Dispalay the cursor position in range/bearing or lat/long.
20. Alm sense LV
Select minimau echo strength which triggers guard alarm.
21. Dead Sector
Select “On” to display the dead sector.
22. Range
Select ranges in use.
23. Self Test
Test keys, ROM and RAM, check antenna rotation speed, and
display program no.
24. Installation Setup
Go to the installation setup menu.