Frymaster 8SMS User Manual

Page 27

Advertising
background image

6-2

6.2

Accessing Equipment for Servicing

DANGER

Moving this equipment while it is filled with hot water may cause spilling or

splattering of the hot water. Always drain the cookpot before attempting to relocate

this equipment for servicing.


1. Disconnect the unit from the electrical power supply and from the water supply.

2. Remove any attached restraining devices.

3. Relocate the unit for service accessibility.

4. After servicing is complete, reconnect the unit to the water supply, reattach restraining devices,

and reconnect the unit to the electrical power supply.


6.3

Replacing Equipment Components


6.3.1 Replacing the Controller

See Section 5.4.

6.3.2 Replacing the Transformer, Basket Lift Relay, Contactor, or Solenoid Valve

1. Drain the cookpot and disconnect the cooker from the electrical power supply.

2. Remove the cover from the component box.

(It may be helpful to remove the drain
plumbing below the drain valve to better
access the interior of the component box.)


3. On the component to be replaced, make a

note of the wiring connection points.


4. Disconnect the wires and remove the failed

component (see illustration on next page).
Install the replacement component and
reconnect the wiring in accordance with the
notes made in Step 3 or with the wiring
diagram on the door of the unit.


5. Replace the component box cover, being sure to reconnect the ground wire. Replace any drain

plumbing components that were removed and reconnect the cooker to the electrical power
supply.

Advertising
This manual is related to the following products:

8C, 8BC