FOCUS Enhancements DVCPRO50 - Manual (Page 72)

FS-100 Functions
54 FS-100 Portable DTE Recorder
TC SET
The Timecode Set parameter stores a user defined timecode in the
FS-100’s non-volatile memory. This value is available for use by the
FS-100 immediately after exiting
TC SET .
• TC FREE RUN
The FS-100 uses this value on the next recording after it is set
in
TC SET .
• TC REGEN
This is the starting value when using an empty hard disk
drive for recording.
• TC REC RUN
This is the value used to begin every recording session after a
power cycle.
TC SET
00 : 00 : 00 : 00
HH : MM : SS : FF
BACK