Fostex VF08 - Manual (Page 10)

1. After turning on both the VF08 and the CD-RW drive
connected, insert a disc to the CD-RW drive.
2. Press the [SETUP] key of the VF08 to enter the setup
mode.
The display shows the screen for selecting the setup menu.
In the following procedure, we assume that a CD-RW
drive is connected to the SCSI port of the Model 8340
installed in the VF08 and a non-recorded CD-RW/CD-
R disc is used.
4. While “SCSI” is flashing, press the [ENTER/YES] key.
After briefly showing the model name of the connected
CD-RW drive, the display shows the screen for selecting a
save mode, where
“BkUp” (backup) is flashing.
To save (backup) song data, select “BkUp” .
To make an audio CD, select “CD-DA” or “Setup” .
This procedure describes how to save song data, so we
select
“BkUp” here.
See “making an audio CD” described later for details about
how to make an audio CD.
3. Use the [JOG] dial to select (highlight) “Save PGM” and
press the [ENTER/YES] key.
The display shows the screen for selecting a save device,
where
“SCSI” is flashing. 6. After selecting a program, press the [ENTER/YES] key.
The display shows the screen as below.
When completing the save operation, “Save Completed!”
appears on the display (as shown below) and the VF08
stops access to the drive, while the disc in the CD-RW
drive is automatically ejected.
In the example above, the selected program data will be
saved to a CD-RW/CD-R disc with the backup number
“B01” . The program title is copied to the backup title
(you can not edit it).
By rotating the
[JOG] dial when the above screen is shown,
you can also select “Eject” , besides “B01” .
If you select “Eject” and then press the [ENTER/YES] key,
the disc will be ejected.
<Note>
Do not carry out any VF08 key operation until the access
process to the CD-RW/CD-R disc is completed.
flashing
Saving data using a CD-RW drive (Backup)
By rotating the [JOG] dial, you can select a desired pro-
gram number/title from among available programs in
the VF08 current drive. The recorded space of the se-
lected program is also shown.
If you select a program which requires more than one
disc for saving, the display shows the required number
of discs (see the screen example below).
5. While “BkUp” flashing, press the [ENTER/YES] key.
The display shows the screen for selecting a program to
be saved (the program number of the selected program
flashes).
7. While “B01” is shown, press the [ENTER/YES] key.
The VF08 starts the save operation. The recorded space
shown on the display is counted down while the save
operation progresses. It will take some time for saving all
data. The following display example shows that the data
of the selected program number is being saved to the
backup number
“B01” .
10
flashing
flashing
recorded
space
number of
discs
flashing