Fostex VF08 - Manual (Page 15)

To change the setting, press the [ENTER/YES] key when
the “CD-DA Setup” screen is shown.
The current setting starts flashing, showing it can be ed-
ited. While flashing, use the
[JOG] dial to select “ON” or
“OFF” , then press the [ENTER/YES] key to confirm.
Copy protection setting
You can restrict the disc copy (duplication) ca-
pability of an audio CD you are going to make.
7. While “CD-DA” is flashing, press the [ENTER/YES] key.
After showing “Please Wait!” , the display shows the screen
for selecting the program(s) to be record.
In the screen, a number such as
“01” or “02” shows the
track number, while “NON” shows that no program is
assigned to the track.
9. Use the [JOG] dial to select a desired program and press
the [ENTER/YES] key.
The selected program is set to the first track.
6. After setting the copy protection, press the [EXIT/NO]
key.
The display returns to the screen for selecting the save
mode, in which
“CD-DA” now flashes.
“ON” A disc you made can be copied to other digital
device once.
“OFF” A disc you made can be copied to other digital
device as many times as required (default).
<Note>
If the program time shows “00: 00” when select-
ing a program as the screen example below, the
“Start” and “End” points are not correctly set.
In other words, in the following conditions,
the
“Start” and “End” points are not regarded
as being correctly set.
“Start point” = “End point”
“Start point” > “End point”
If you press the [ENTER/YES] key after selecting
such a program, the warning message as below
appears on the display and you cannot select
the program.
“Void In!”, “Void Out!”, or “Void Data!”
<Note>
It is possible to select a program that is not
internal mastering if it holds the correct
“Start”
and “End” points.
However, if you record such a program to a
CD-RW/CD-R disc with the audio CD format,
only track 1 and 2 can be recorded.
So, make sure that you select programs prop-
erly when making an audio CD.
• To record a single song to a CD-RW/CD-R disc, select a
program and press the [ENTER/YES] key, and then go
to step 10.
• To record more than one song to a CD-RW/CD-R disc,
repeat the procedure for selecting a program
described above (i.e. use the
[JOG] dial to select a
program and press the [ENTER/YES] key) until
selecting all desired programs, and then go to step 10.
15
8. Press the [ENTER/YES] key again.
The display shows the screen in which the last program
number of the current drive flashes. Its program title and
recording time are also shown, while the total time of
songs is shown at the top of the screen.
Data between the
"Start point" and "End point" is
transferred to an audio CD. Before executing recording,
we recommend you to confirm that the actual audio in
the program starts just after the
"Start point" and ends
just before "End point" .
flashing
flashing
flashing
flashing