Fostex VF08 User Manual
Page 16
10. After specifying the program(s), press the [ENTER/YES]
key while holding down the [RECORD] key.
The VF08 starts recording to the disc, while the display
shows the following screen.
<Notes for selecting more than one program>
When recording more than one program to a CD-RW/
CD-R disc, do not skip any track when assigning pro-
grams to tracks.
If you skip any track, you cannot record data to the
subsequent tracks. In the following example, track 03
is skipped when assigning programs.
So only tracks 01 and 02 will be recorded. Tracks 03
and subsequent tracks can not be recorded.
<Hint>
When a CD-RW disc on which any data is recorded
is set, if you perform step 7 above (i.e. pressing the
[ENTER/YES]
key when
“CD-DA”
is flashing),
“Not
Empty!”
appears on the display, followed by the
screen for selecting whether erasing recorded data
or ejecting the disc.
• If you erase recorded data:
Press the
[ENTER/YES]
key while
“ERASE”
and
“Sure?”
are flashing.
After the key press, the display changes as follows
and the VF08 starts erasing the data. As the eras-
ing process is going on, the number of flashing
“ * ”
increases.
When erasing is completed, the display shows the
same screen which appears when pressing the
[EN-
TER/YES]
key after selecting
“CD-DA”
on step 7
above. So follow the same procedure from step 8
on page 15.
Increases as the process progresses.
• If you eject the disc:
Use the
[JOG]
dial to make
“Eject”
flashing and then
press the
[ENTER/YES]
key.
The disc is ejected, while
“Insert Disk!”
appears on
the screen.
When inserting a blank disc, you can go on the
next step (see the procedure described above).
When the recording ends,
“Save Completed!”
appears on
the screen, while the disc is automatically ejected from
the CD-RW drive.
<Note>
When making an audio CD, if you select a program
which consumes more disc space than the recordable
space of a CD-RW/CD-R disc,
“Disk Full!”
appears on the
display and you cannot select the program.
16
<Hint>
Some of our operation-confirmed CD-RW drives
can playback audio CDs and feed audio sound
from their headphones jack or line outputs.
In such a case, you can monitor the sound ei-
ther from headphones connected to the head-
phone jack of a drive or from the monitor sys-
tem connected with the VF08. In the latter way,
connect the line outputs of the CD-RW drive to
the inputs of the VF08 and route the playback
signals to the headphone outputs via the VF08
track faders.
11. When completed, press the [EXIT/NO] key to quit the
Setup mode.
flashing
flashing
flashing
flashing