Fostex VF08 User Manual
Page 11
<About save error>
If an error occurs for some reason during the
save operation, the error message as below ap-
pears. If it appears, press the
[EXIT/NO]
key.
The display returns to the previous screen be-
fore performing the save operation.
Note that saved data before the error message
appears is all invalid.
<Note for saving data to more than one disc>
If you save data to more than one disc, we rec-
ommend to put a number on each disc in the
saving order (such as DISC-1, DISC-2, etc.) so that
you will easily know the order for inserting discs
when loading data.
<Hint 1>
In the description for saving data above, we as-
sume to use a non-recorded CD-RW/CD-R disc.
If you use a recorded disc (including a disc on
which computer data is recorded), also note the
following.
By performing step 5 in the save operation proce-
dure shown above (“While
“BkUp”
is flashing, press
the
[ENTER/YES]
key”.) When a recorded disc is
inserted, the display shows a warning message,
followed by the confirmation screen (where
“Sure?”
flashes).
With this screen, you can choose whether erasing
the recorded data or ejecting the disc.
• To erase the existing (recorded) data
Press the
[ENTER/YES]
key while both
“ERASE”
and
“Sure?”
are flashing.
The display shows the screen below and the VF08
starts erasing the disc.
As the erase process progresses, the number of
flashing
“ * ”
increases from left to right.
Immediately after completing erasing the disc, the
display shows the same screen (for selecting a pro-
gram to be saved) which appears after step 5 is
performed. Hereafter, perform the same procedure
as described above.
<Note>
You cannot abort the save operation before com-
pleted. Especially during the save operation to
more than one disc, if you happen to press the
[EXIT/NO]
key while removing or inserting a disc,
you have to redo the save operation from the
beginning with the first disc.
<Note>
If the message above appears while saving
data to a CD-R disc, you can no longer use the
disc.
8. Press the [EXIT/NO] key (or the [STOP] key) to exit the
Setup mode.
When saving data to more than one disc, the first disc
will be ejected when it is full (i.e. there is no more record-
ing space on the disc), while
“Insert Disk!”
appears on the
screen. After inserting the second disc, the VF08 auto-
matically resumes the save operation.
After completing the save operation, the final disc is
ejected and the above screen appears. (See
<Note>
be-
low).
11
flashing
flashing
flashing
flashing
Increases as the process progresses.