Connection to a tv, 15 en 15 en, Rca video cable and or or – FUNAI ZC350MS8 User Manual
Page 15
15
EN
15
EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
Others
Español
Make one of the following connections, depending on the capabilities of your existing device.
Note
• Connect this unit directly to the TV. If the RCA audio/video cables are connected to a VCR, pictures may be
distorted due to the copy protection system.
• When “Progressive Scan” is set to “ON”, no video signal will be output from the VIDEO OUT or S-VIDEO OUT
jack.
After you have completed the connections
• Switch the input selector on your TV to an appropriate external input channel. Press a button on the TV’s original
remote control that selects an external input channel until the DVD recorder’s opening picture appears. Check your
TV owner’s manual for details.
To set progressive scan mode, refer to page 84
• This unit is compatible with the progressive scan system. The feature provides you with the higher quality images than the
traditional output system does. To utilize this feature, you must set “Progressive Scan” to “ON”.
CONNECTION TO A TV
Supplied cables used in this connection are as follows:
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your local store.
VIDEO
IN
AUDIO IN
(E1)
S-VIDEO
ANTENNA
AUDIO OUT
IN
L
R
L
R
VIDEO
OUT
IN
OUT
AUDIO IN
L
R
AUDIO OUT
L
R
VIDEO
OUT
AUDIO OUT
L
R
S-VIDEO IN
S-VIDEO
OUT
COMPONENT
VIDEO OUT
Y
P
B
/C
B
P
R
/C
R
COMPONENT
VIDEO IN
Y
P
B
/C
B
P
R
/C
R
(Green)
(Blue)
(Red)
(Green)
(Blue)
(Red)
AUDIO OUT
TV
analog audio
Method 2
Method 3
good picture
better picture
S-VIDEO OUT
COMPONENT
VIDEO OUTPUT
RCA audio
cable
S-video cable
component
video cable
this unit
Method 1
standard picture
VIDEO OUT
AUDIO OUT
L
R
VIDEO
OUT
VIDEO
OUT
VIDEO
IN
RCA video
cable
and
or
or
E7H51UD.indd 15
E7H51UD.indd 15
2007/02/19 18:23:27
2007/02/19 18:23:27