FUNAI ZC350MS8 - Manual (Page 9)

9 EN 9 EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
Others
Español
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
VIDEO
IN
AUDIO IN
( E1 ) S-VIDEO S-VIDEO ANTENNA AUDIO OUT COMPONENT VIDEO OUT DIGITAL AUDIO OUTPUT PCM/BITSTREAM
IN OUT COAXIAL
L
R
L
R
Y
P B /C B
P R /C R
VIDEO
OUT
IN
OUT
2 1
8
3 4
7 9 5 6 11 10
FUNCTIONAL OVERVIEW
1. ANTENNA IN jack
Use to connect an antenna.
2. VIDEO IN jack (E1)
Use to connect external device with a RCA video
cable.
3. VIDEO OUT jack
Use to connect a TV monitor, AV receiver or other
device with a RCA video cable.
4. AC Power Cord
Connect to a standard AC outlet to supply power to
this unit.
5. COAXIAL DIGITAL AUDIO OUTPUT jack
Use to connect an AV receiver, Dolby Digital decoder
or other device with a coaxial digital input jack with a
digital coaxial cable.
6. S-VIDEO OUT jack
Use to connect the S-video input of a TV monitor, AV
receiver or other device with an S-video cable.
7. COMPONENT VIDEO OUTPUT jacks
Use to connect a TV monitor with component video
inputs with a component video cable.
8. AUDIO OUT jacks
Use to connect a TV monitor, AV receiver or other
device with a RCA audio cable.
9. S-VIDEO IN jack (E1)
Use to connect the S-video output of external device
with an S-video cable.
10. AUDIO IN jacks (E1)
Use to connect external device with a RCA audio
cable.
11. ANTENNA OUT jack
Use to connect an RF coaxial cable to pass the signal
from the ANTENNA IN to your TV.
Rear Panel
E7H51UD.indd 9 E7H51UD.indd 9 2007/02/19 18:23:23 2007/02/19 18:23:23