Functional overview, 12 en 12 en – FUNAI ZV457MG9 A User Manual

Page 14

Advertising
background image

12

EN

12

EN

FUNCTIONAL OVERVIEW

Using a Remote Control

17

21
22

23

26

29

33

2

3

4

6

8

10

12

11

15

5

27

19

18

1413

16

31

1

9

24

25

28

30
32
34

20

7

Keep in mind the following when using the remote
control:
• Make sure that there are no obstacles between the remote

control and the infrared sensor window on the unit.

• Remote operation may become unreliable if strong

sunlight or fluorescent light is shining on the infrared
sensor window of the unit.

• Remote control for different devices can interfere with

each other. Avoid using remote control for other device
located close to the unit.

• Replace the batteries when you notice a fall off in the

operating range of the remote control.

• The maximum operable ranges from the unit are as

follows.

- Line of sight: approx. 23 feet (7m)
- Either side of the center:
approx. 16 feet (5m) within 30°
- Above: approx. 16 feet (5m) within 15°
- Below: approx. 10 feet (3m) within 30°

Install the batteries (AAx2) matching the polarity
indicated inside battery compartment of the remote
control.

Note

Incorrect use of batteries can result in hazards such as
leakage and bursting. Please observe the following:
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.

Although they may look similar, different batteries
may have different voltages.

• Make sure that the + and - ends of each battery

match the indications in the battery compartment.

• Remove batteries from battery compartment that is

not going to be used for a month or more.

• When disposing of used batteries, please comply

with governmental regulations or environmental
public instruction’s rules that apply in your country
or area.

• Do not recharge, short-circuit, heat, burn or

disassemble batteries.

16 feet (5m)

30˚

16 feet (5m)

30˚

23 feet (7m)

Remote Control

Installing the Batteries in the Remote Control

1

Open the cover.

2

Insert batteries.

Make sure to match + and - on the batteries to
the marks indicated in the battery compartment.

3

Close the cover.

E9S80UD_ZV457MG9_v1.3.indd 12

E9S80UD_ZV457MG9_v1.3.indd 12

2009/02/10 15:18:42

2009/02/10 15:18:42

Advertising