FUNAI ZV457MG9 A - Manual (Page 18)

16 EN 16 EN
Connecting to a TV with an HDMI™ Compatible Port
HDMI Mode and Actual Output Signals
Press [HDMI] to select the HDMI output mode. The output mode changes as follows every time [HDMI] is pressed.
Front Panel Display Video Output Signal
480 Progressive
Press [HDMI]
720 Progressive
Press [HDMI]
1080 interlaced
Press [HDMI]
1080 Progressive
Press [HDMI]
• The HDMI mode that is not supported by display device will be skipped.
Copyright protection system
To play back the digital video images of a DVD via an HDMI
connection, it is necessary that both the player and the
display device (or an AV amplifier) support a copyright
protection system called HDCP (high-bandwidth digital
content protection system). HDCP is copy protection
technology that comprises data encryption and
authentication of the connected AV device. This unit
supports HDCP. Please read the operating instructions of
your display device (or AV amplifier) for more information.
Note
• Some devices with an HDMI input may not operate properly with this unit.
• When using an HDCP-incompatible display device, the image will not be viewed properly.
• Among the devices that support HDMI, some devices can control other devices via the HDMI connector; this unit cannot be
controlled by another device via the HDMI connector.
• The audio signals from the HDMI connector (including the sampling frequency, the number of channels and bit length) may be
limited by the device that is connected.
• Among the monitors that support HDMI, some do not support audio output (for example, projectors). In connections with device
such as this unit, audio signals are not output from the HDMI output connector.
• When this unit’s HDMI connector is connected to a DVI-D compatible monitor (HDCP compatible) with an HDMI-DVI converter cable,
the signals are output in digital RGB.
• When the power failure occurs, or when you unplug the unit, some problems in the HDMI setting might occur. Please check and set
the HDMI setting again.
• HDMI video resolution cannot be changed when the unit is in VCR mode.
• HDMI outputs the video / audio signals without converting to analog signals.
• No audio connection is required.
CONNECTION
HDMI IN
HDMI OUT
rear of this unit
OUT
IN
ANTENNA
DIGITAL AUDIO OUT AUDIO OUT S-VIDEO
IN
COAXIAL
L
R
L
R
L
R
S-VIDEO IN --- AUDIO --- OUT
IN --- VIDEO --- OUT
OUT
Y
P B /C B
P R /C R
COMPONENT VIDEO OUT
DVD/VCR
HDMI OUT
OUT
IN
ANTENNA
VHF / UHF
antenna
cable TV
company
or
ANT. IN
This connection is for
TV loop through only
RF coaxial
cable
RF coaxial cable
Do not tilt the connector when inserting it into the HDMI jack, and make sure the
shapes of the jack and the connector are matched.
HDMI cable
Supplied cables used in this connection are as follows:
• RF coaxial cable x 1
Please purchase the rest of the necessary cables at your local store.
*HDMI: High Definition Multimedia Interface
E9S80UD_ZV457MG9_v1.indd 16 E9S80UD_ZV457MG9_v1.indd 16 2008/12/12 15:15:09 2008/12/12 15:15:09