FUNAI ZV457MG9 A - Manual (Page 33)

31 EN 31 EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
VCR Functions
Others
Español
SETTING THE CLOCK
Set the clock before you try the timer programming. If a PBS (public broadcasting station) is available in your area,
follow “Auto Clock Setting” below. If not, follow “Manual Clock Setting” on page 32.
Note
• The clock may set itself automatically after you connect
the antenna/cable signal and plug in the power cord.
• Only the analog PBS channel signal is effective for auto
clock setting.
• The unit receives the clock data at 12:00 a.m. / p.m.
from the PBS channel when the unit is in the standby
mode.
1 Press [SETUP] and use [K / L] to
select “General Setting”, then press
[OK].
“General Setting” menu will appear.
2 Use [K / L] to select “Clock”, then
press [OK].
“Clock” menu will appear.
3 Use [K / L] to select “Auto Clock
Setting”, then press [OK].
4 Use [K / L] to select “Auto”, then
press [OK].
Auto Clock Setting
OFF
Auto
Manual
5 Press [SETUP] to exit.
6 Press [STANDBY-ON y y ] to turn the
unit to the standby mode.
This unit will search for the time only when the
power is in the standby mode. Leave it in
standby for several minutes to give this unit time
to set the clock.
Auto Clock Setting
This unit can set the time and date automatically by
referring to a PBS station.
Make sure
• The antenna/cable TV connections are correct.
• Channels are set. (Refer to page 28.)
• If this unit is connected to a cable/satellite box,
select the local PBS station on them to set the clock
automatically.
1 Select “Manual” at step 4, then press
[OK].
2 Use [the Number buttons] or [K / L]
to enter your PBS channel number,
then press [OK].
Set Channel No.
CH 1
3 Press [SETUP] and turn the unit to
the standby mode.
If the unit chooses an incorrect PBS channel, set the PBS
channel manually by following the steps below.
E9S80UD_ZV457MG9_v1.indd 31 E9S80UD_ZV457MG9_v1.indd 31 2008/12/12 15:15:41 2008/12/12 15:15:41