FUNAI ZV457MG9 A - Manual (Page 17)

15 EN 15 EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
VCR Functions
Others
Español
CONNECTION
Read this first:
1) Disconnect the AC power cords of the devices from the AC outlet.
2) Make the connection as illustrated below.
3) After making all the connections, connect the AC power cords of the devices.
Antenna Connection (Required)
This connection is for
TV loop through only
OUT
IN
ANTENNA
VHF / UHF
antenna
cable TV
company
RF coaxial cable
or
RF coaxial
cable
ANT. IN
HDMI OUT
rear of this unit
DIGITAL AUDIO OUT AUDIO OUT S-VIDEO
OUT IN
COAXIAL
L
R
L Y
P B /C B
P R /C R
R
L
R
S-VIDEO IN --- AUDIO --- OUT
IN --- VIDEO --- OUT
COMPONENT VIDEO OUT
DVD/VCR OUT
IN
ANTENNA
Choose one of the following connections
depending on the jacks on your TV.
Note
• For your safety and to avoid damage to the device, please unplug the RF coaxial cable from the ANTENNA IN jack before
moving the unit.
• If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be
more effective than set-top versions.
• ANTENNA OUT jack is for tuner pass through only. DVD playback through the RF is not possible.
Supplied cables used in this connection are as follows:
• RF coaxial cable x 1
Please purchase the rest of the necessary cables at your local store.
Overview
If Your TV has Refer to
If you are using
cable / satellite box
Standard
Quality
Higher
Quality
If your device has
only an ANT. IN jack
page
16
COMPONENT VIDEO IN
AUDIO IN
L R
VIDEO IN
page
20
page
19
page
17
page
17
page
18
S-VIDEO IN
HDMI IN
ANT. IN
• Connect this unit directly to the TV. If the RCA audio/video cables are connected to a VCR, pictures may be
distorted due to the copy protection system.
E9S80UD_ZV457MG9_v1.indd 15 E9S80UD_ZV457MG9_v1.indd 15 2008/12/22 15:50:58 2008/12/22 15:50:58