FUNAI ZV457MG9 A - Manual (Page 30)

28 EN 28 EN
CHANNEL SETTING
If you have changed antenna connection, we recommend that you program available channels in your area with the
following procedures.
1 Press [SETUP] and use [K / L] to
select “General Setting”, then press
[OK].
“General Setting” menu will appear.
2 Use [K / L] to select “Channel”, then
press [OK].
“Channel” menu will appear.
3 Use [K / L] to select “Auto Channel
Preset”, then press [OK].
4 Use [K / L] to select the type of
broadcasting signal, then press [OK].
Auto Channel Preset
Antenna
Cable (Analog)
Cable (Analog / Digital)
The unit will start getting channels available in
your area.
• When aerial antenna is connected, select
“Antenna”.
• When connected to CATV, select “Cable
(Analog)” or “Cable (Analog / Digital)”.
To cancel the auto channel preset during
scanning:
Press [RETURN] to go the previous screen or
[SETUP] to cancel.
5 When scanning is over, press [SETUP]
to exit.
To cycle through only the memorized channels, use
[CHANNEL / ].
To select a channel directly (including the ones not
memorized), use [the Number buttons] and [ • ] (for
digital TV channels).
Auto Channel Scan
Note
• If the auto channel preset is canceled during
presetting, some channels not yet preset may not be
received.
• You cannot change the channel when either VCR or
DVD is in any recording mode (basic recording, one-
touch timer recording or timer recording).
E9S80UD_ZV457MG9_v1.indd 28 E9S80UD_ZV457MG9_v1.indd 28 2008/12/12 15:15:32 2008/12/12 15:15:32