FUJITSU DL6400 User Manual
Page 2
User’s Manual
Federal Communications Commission
Radio Frequency Interference Statement
for United States Users
Notice:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING:
Changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority
to operate the equipment.
(This equipment has been tested as M3390A/M3391A of the model
number.)
Notes:
1. The use of a nonshielded interface cable with the referenced device
is prohibited. The length of the parallel interface cable must be 3
meters (10 feet) or less. The length of the serial interface cable must
be 15 meters (50 feet) or less.
2. The length of the power cord must be 3 meters (10 feet) or less.
DL6400/6600 Book Page 1 Friday, July 31, 1998 11:42 AM