Fisher & Paykel DISHDRAWER DD603I - Manual (Page 4)

FITTING THE HANDLE
Fit the customer supplied handle.
WARNING!
When mounting the handle, be sure fastenings do not protrude
beyond the back surface of the Panel.
FITTING THE BADGE
Fit a Badge to each Panel by feeding the wires through to the back and
pressing the Badge into the cut out. If needed adhere the Badge to the
Panel with an adhesive.
Feed the Badge wires through the slot in the Mounting Bracket. As the
Mounting Bracket is placed on the rear of the Panel the excess wire must
be pulled through.
R
PANEL PREPARATION INSTRUCTIONS
STEP 4:
SECURING THE MOUNTING BRACKETS
STEP 3:
FITTING THE HANDLE AND BADGE
4
Each Mounting Bracket is directly screwed to the back of each Integrated
Panel. On a soft surface centralize and align the Upper Mounting Bracket
on the Upper Panel and the Lower Mounting Bracket on the Lower Panel.
Important!
For some materials pilot holes may need to be drilled first before
screwing the Mounting Bracket onto the Panel. Be sure the drill does
not damage the face of the Panel.
Important!
The mounting bracket must not be modified in any way. It is
designed to hold the door front in the correct position to allow
venting.
Important!
The top door front must not extend beyond the bottom of the
mounting bracket. Drying problems and moisture damage may
otherwise occur.
Important!
Break off the tab at the top of the Lower Mounting Bracket, after
Panel has been secured.
Using six of the 5 /
8
” (16mm) screws supplied, secure the Mounting
Bracket to each Panel at the six points shown in the diagram.
NOTE: If the the six outermost slots are not able to be used
to securely fix the Mounting Brackets to the Panel, choose
any six well spaced slots about the Panel.