Fisher & Paykel DISHDRAWER DD603I - Manual (Page 8)

BEFORE YOU START
IMPORTANT
INTEGRATED PANEL THICKNESS
Panel minimum thickness is 16mm. Panel thicknesses above 18mm can
be accommodated but product depth will increase accordingly.
INTEGRATED PANEL MATERIAL
Drawer Front material must be suitable for damp conditions
(122
o F/50 o C @ 80% RH) or adequately sealed to withstand moisture.
Additional protection can be provided by using a “Moisture Resistant
Board”. Taping edges alone may not provide adequate sealing. For
painted panels, radius all rear edges to improve sealing.
LOW INSTALLATIONS
Use this diagram if installing the near floor level.
TOOLS NEEDED
Safety Glasses, Tape Measure, Pencil, Needle-Nose Pliers, Drill & Phillips
Bit or Phillips Screwdriver,
ø
1” (25.4mm) Boring Bit or
ø
1” (25.4mm)
Hole Saw, Small Hand or Jig Saw.
PARTS SUPPLIED
INTEGRATED PARTS KIT part no. 526675
Panel
Preparation
Booklet (1) Panel
Mounting
Screws (6)
Door Front Seal (1)
p.n 526466
Mounting Bracket (1)
p.n 526440
Integrated Rectangular Badge (1)
(Satin Chrome supplied)
p.n 526975
Other Colours Available
Rectangular:
Bright Chrome Kit p.n 527276
Brass Kit p.n 527277
Eliptical:
Black Kit p.n 526683
Satin Chrome Kit p.n 526684
Bright Chrome Kit p.n 527156
Brass Kit p.n 526685
2
WARNING!
ENSURE THE PRODUCT IS NOT PLUGGED IN.
Important!
The installation of the Panel requires an electrical
connection and must be performed by a suitably
qualified person.