Faria Instruments SMARTCRAFT MG2000 - Manual (Page 44)

This function is used to tell the system whether or not the Fuel 2
Sensor is installed.
Press “Up” or “Down” to scroll through the selections.
When the correct choice is next to the selection arrow “>”, Press and
hold the “Up” and “Down” buttons together for 2 seconds to save
the selection.
Fuel 2
Sensor
No
> Yes
The screen returns to the “Fuel 2 Sensor Installed?” screen.
Press “Up” or “Down” to select another “Edit” mode edit function.
Otherwise,
Press the “Mode” button to return to the “Normal” mode.
Fuel 2
Sensor
Installed?
Calibrate Trim Sync
From the “Edit” mode, using the “Up” or “Down” buttons, select the
“Calibrate Trim Sync” edit function.
Press and hold the “Up” and “Down” buttons for 2 seconds to select
the “Calibrate Trim Sync” Follow the instructions below.
Otherwise,
Press the “Up” or “Down” button to select another function or
“Mode” to return to “Normal” mode.
Calibrate
Trim Sync
This function is used to balance the trim sync display on a boat with
more than one engine. Set the trim on each engine to the same
positions and then perform the “Calibrate Trim Sync.”
Press and hold the “Up” and “Down” buttons together for 2 seconds
to save the selection.
Trim Sync
To Calibrate
Press Up
And Down
Press “Up” or “Down” to select another “Edit” mode edit function.
Otherwise,
Press the “Mode” button to return to the “Normal” mode.
Calibrate
Trim Sync
Page 38