Faria Instruments SMARTCRAFT MG2000 - Manual (Page 7)

Ref. Tools Description
1. 3/8” Nut Driver
Disconnect the battery during installation. Tighten nuts on the backclamp only
slightly more than you can tighten with your fingers. Six inch-pounds of torque
are sufficient. Over-tightening could result in damage to the instrument and
may void your warranty.
Figure 1
Use this manual for the SmartCraft™ MG2000™ Tachometer.
Tools Required
Cut a 3-3/8” diameter hole in the
dash for the 4” gauge. Mount the
gauge with the backclamp supplied.
Cut a 4-3/8” diameter hole in the
dash for the 5” gauge.
Small Connector Socket
Follow the wiring diagram at the end
of this manual for connections. (See
page 53)
Large Connector Socket
Follow the wiring diagram at the end
of this manual for connections. (See
page 46, 48, 50 and 51 depending
on your connection type.)
Installation
Page 1
1.
2.
3.
Note: For wiring, see diagrams
HN0403 (page
46 )
HN0407 (page 48)
HN0565 (page 50)
HN0566 (page 51)
HN0401 (page 53)