Furuno CH-300 - Manual (Page 59)

3-1
3. VERTICAL SCAN MODE
3.1 Operational Overview
The figure below shows the typical vertical scan mode operating sequence.
2. Lower the transducer.
9. Adjust gain.
7(a). Set scanning sector.
6. Set train bearing.
5. Set range.
8. Set tilt angle.
3. Adjust screen
brilliance.
7(b). Select training sector 180
°
.
4. Select appropriate
vertical scan mode.
10. Measure range and
bearing to target with cursor.
11. Adjust menu settings
(ex. TVG) as required.
1. Turn on the power.
SECTOR TRAIN RANGE TILT
FULL
HALF
FAST
SCAN
TARGET BRILL MENU
R/B EVENT
CUSTOM MODE
POWER
XDR
REVERSE
LF
HF
MAIN
SUB
MIX
DISPLAY MODE
GAIN(PUSH)
Control panel