Furuno CH-300 - Manual (Page 90)

5. MENU OPERATION
5-4
5.3 Short-cut Menu, Preset Menu
These menus program the CUSTOM MODE keys [1], [2] and [3], and one of the menus
appears according to the setting of CUSTOM KEY on the SYSTEM SETTING 1 menu.
Short-cut key:
One-touch activation of corresponding dialog box. This is the default setting.
Preset key:
One-touch setup of mode, sector, train, range, tilt and speed controls. Below
are the default settings for PRESET.
CUSTOM
MODE key
Display Mode Frequency Sector Train Range (m)* Tilt
Key 1 Horizontal expansion LO 240 ° 0 ° 200 30 °
Key 2 Horizontal
HI
360 ° 0 ° 200 30 °
Key 3 Vertical scan
LO
180 ° 90° 120 90 °
5.3.1 Choosing short-cut or preset
1. Press the MENU key to open the menu.
2. Press ▲ to choose MENU, and then press ► to choose SYS.
NO YES
: SELECT : CHANGE MENU: END
GO TO SYS MENU
MENU COM1 HORZ VERT ES PRESET COM2 SYS
Display for opening system menu
3. Press ▼ to choose GO TO SYS MENU.
4. Press ◄ to choose YES.
RANGE-SONAR MODE
RANGE-VERTICAL MODE
RANGE-E/S MODE
ADJ MOTION SENSOR
TX FREQ ADJUST
TEST
TEST PATTERN
DEMO MODE
DEFAULT
: SELECT : MENU DISPLAY MENU: END
SYSTEM SETTING :
COLOR PALETTE
LANGUAGE
SYSTEM BACKUP
LOAD BACKUP DATA
HEADING OFFSET, DRAFT OFFSET
** SYSTEM MENU **
RANGE-TRACK MODE
System menu