FUJITSU SCANSNAP! FI-4110EOX2 - Manual (Page 32)

16
■ Connecting the USB Cable
Connect the USB cable by the following procedure.
1. Attach the ferrite core onto the USB cable.
2. Remove the seal put on the rear side of ScanSnap! scanner.
3. Insert the USB cable into the USB connector on ScanSnap! scanner.
Insert firmly as far as it can go.
ATTENTION
• Use the accessory USB cable. Operation with a commercially available USB
cable is not guaranteed.
• When connecting to a USB hub, be sure to connect to the hub (first stage)
nearest your computer. If you connect to a USB hub from the second stage
onwards, ScanSnap! scanner may not function.
USB connector
AC adapter connector
Cover open lever
Seal
USB connector