Vehicles without body-side cladding – GM Chevrolet Avalanche User Manual

Page 388

Advertising
background image

A. Low-Beam Headlamp
B. High-Beam Headlamp

5. Turn the bulb connector counterclockwise and pull it

out of the housing.

6. Unplug the electrical connector from the old bulb.
7. Plug in the electrical connector to the new bulb. Use

care not to touch the new bulb with your bare
hands or anything damp or oily.

8. Place the connector with the new bulb into the

headlamp housing and turn it clockwise until it is
tight.

9. Put the headlamp assembly back into the vehicle

and reinstall the two pins.

10. Place the inboard end of the turn signal/parking

lamp housing into the pocket.

11. Push the outboard side of the housing in until the

release clip snaps into place.

Vehicles without Body-Side Cladding

1. Remove the pin on the headlamp assembly by

turning the pin up and pulling it straight out.

2. Pull the headlamp assembly out.

5-54

Advertising