GE ZV48R - Manual (Page 14)

14
Installation Instructions
STEP 7 INSTALL FILTERS
• To remove the filters, grasp the latch, pull the filter
up and lift out.
• Drop grease tray into the hood. The rear tabs should
engage the slots in the hood track.
STEP 8 INSTALL BACKGUARD AND SHELF This hood can be installed with the
warming shelf and backguard together or
with the warming shelf or backguard alone.
INSTALL BACKGUARD:
• Remove packaging.
• Place backguard against the bottom of the hood to
use as a template. Mark upper screw locations “A”
and “B”
• Remove backguard.
• Drill four 1/8" pilot holes at screw locations “A”
and “B”.
• If drill did not enter studs, enlarge holes to 3/8".
• Insert wall anchors into the enlarged holes. Remove
screws from wall anchors.
• Align and secure backguard to wall using 2 wall
anchor screws or wood screws in locations “A”.
• For 30" and 36" models, install 2 screws through
hole locations “C” at the bottom of the backguard.
For 48" models, install 4 screws.
INSTALL SHELF OVER BACKGUARD:
• Install two shoulder screws into holes “D” in the
bottom of hood flange leaving 1/8" gap.
• Remove shelf packaging and protective film.
• Engage shoulder screws into the keyhole slots in the
top of the shelf. Slide shelf towards the left to lock
into place.
• Install two 3/4" long machine screws through the
bottom of the shelf into the bottom hood flange,
location “E”.
• Install anchor screws through the shelf and into the
wall holes “B”.
• Remove all protective film.
• If installing the backguard alone, without the
shelf, drive screws in all locations shown.
1/8"
Gap
D
B
E
D
E
B
Mounting
Holes for
Backguard (A, C)
and Shelf (B)
C
BACKG
UARD
A
A
B
B
• Insert the filter into the opening and drop into the
bottom. Raise filter to the top and lock into place.