GSI Outdoors PNEG-630 - Manual (Page 94)

Portable Dryer Troubleshooting
93
Competitor Wiring Reference
Programming Instructions Using Palm Pilot
On the Competitor Dryer there is only one board to program. This board is called the CPU
Display board. It is mounted to the door of the lower box. To access, open the door and the pro-
gramming jack is located on the back of this board. To program, follow the instructions below.
1. Turn the control power on the dryer to the off position.
2. Locate the programming jack (J2 connector) on back of board.
3. Unplug the communications cable that is connected to that connector. This is the cable that
runs from the CPU/Display board and IO Board.
4. Connect the DB-9 connector from the Palm Pilot to the series 2000 cable.
5. On the Palm Pilot select the program for that particular board and tap on it.
6. Turn the dryer control power back on.
7. The programming process should begin, it will erase the present program and start the new
program.
8. A screen will come up telling you when the transfer of software is complete.
9. When the process is complete turn dryer control power off, remove the connector from the
board and plug the communications cable back on to the CPU/Display board.
10. Turn on the dryer and the opening screens should indicate the latest version of software.
Refer to next page for more information on programming the Series 2000 board.
If ordering Palm Pilot from GSI there are two kits available:
D03-0692 ( Palm Flash Program Kit Deluxe )
D01-1771 Series 2000 Programming Cable
D03-0688 Palm Pilot IIIC (color)
D03-0694 Palm Pilot Hot Sync Cable
D03-0695 Palm Flash 9 Pin M-M Adapter
D03-0709 Disk, CD-Rom Palm Flash Software
D03-0693 ( Palm Flash Program Kit Economy )
D01-1771 Series 2000 Programming Cable
D03-0689 Palm Pilot M100 (black & white)
D03-0695 Palm Flash 9 Pin M-M Adapter
D03-0709 Disk, CD-Rom Palm Flash Software