GE JV535 - Manual (Page 5)

5
To clean the hood surface, use a hot,
damp cloth with a mild detergent
suitable for painted surfaces. Use a
clean, hot, damp cloth to remove soap.
Dry with a dry, clean cloth. Do not use steel-wool pads or other
abrasive cleaners. They will scratch
the surface. Wipe with a clean, hot,
damp cloth after using cleansers.
Painted Surfaces (on some models)
Do not use a steel-wool pad; it will
scratch the surface.
Shake bottle well.
Place a small amount of CERAMA
BRYTE
® Stainless Steel Appliance
Cleaner on a damp cloth or damp
paper towel.
Clean a small area (approximately
8
″ x 8″), rubbing with the grain of
the stainless steel if applicable.
Dry and buff with a clean, dry paper
towel or soft cloth.
Repeat as necessary.
NOTE: If a mineral oil-based stainless steel
appliance cleaner has been used before to
clean the appliance, wash the surface with
dishwashing liquid and water prior to using the
CERAMA BRYTE
® Stainless Steel Appliance
Cleaner. After washing the surface with
dishwashing liquid and water, use a generous
amount of CERAMA BRYTE
® Stainless Steel
Appliance Cleaner to clean the appliance.
Stainless Steel Surfaces (on some models)
This hood requires two bulbs (not
included)
, maximum 50 watts.
Purchase and install PAR20, 50 W
Maximum halogen bulbs.
When replacing a bulb, let it cool first.
Make sure that power to the light has
been turned off. Never allow a hot bulb
to come into contact with water.
WARNING:
To reduce the risk of
electric shock, do not connect electrical power
to the hood without both bulbs in place.
To change the light bulbs:
Grasp the bulb on the edges and
unscrew it.
Replace with the same size bulb.
CAUTION:
■
Do not touch the hood light bulbs when they
are on. They may be hot enough to cause
injury.
■
The light bulbs operate at extremely high
temperatures. If they shatter, the hot glass
could cause personal injury.
Hood Lights
NOTE: Charcoal filters are not
included with the hood. They
must be ordered from your
GE supplier.
If the model is not vented
to the outside, the air will
be recirculated through
disposable charcoal filters
that help remove smoke
and odors.
The charcoal filters should
be replaced when they
are noticeably dirty or
discolored (usually after
6–12 months, depending
on hood usage).
NOTE: DO NOT rinse, or put
charcoal filters in an automatic
dishwasher.
Charcoal Filters
(on some models)
The charcoal filters
cannot be cleaned.
They must be replaced.
For 30
″ hood models, order
Kit no. WB02X11000.
For 36
″ hood models, order
Kit no. WB02X11001.
These kits can be ordered
from your GE supplier.
The charcoal filters are clipped inside
of each reusable metal grease filter.
Safety Instructions
Operating Instructions
Installation Instructions
Tr
oubleshooting T
ips
Consumer Support
Care and cleaning of the vent hood.
www.GEAppliances.com
To order:
To order CERAMA BRYTE
® Stainless
Steel Appliance Cleaner, please call our
toll-free number:
National Parts Center. . 800.626.2002
www.GEAppliances.com
CERAMA BRYTE
®
Stainless Steel
Appliance Cleaner. . . . # PM10X311