GE Calibur CBR-PB3-WD - Manual (Page 26)

Kalatel CBR-PB3-WD 26 0150-0261A
10 HyperTerminal Setup
Manual configuration can also be completed using Windows HyperTerminal in
lieu of the dipswitches. Manual configuration should only be used if the “POS
Device Selection” does not conform to your specific device because baud
rates or protocols are slightly different than the default values for the selected
device.
10.1 Equipment Required
q (1) Windows 98/NT/2000/XP Desktop or Laptop PC.
q (1) DB9F to RJ45 cable (included with your unit).
Configuration using Windows HyperTerminal uses
the supplied RJ45-to-DB9 cable provided with
your unit. Disconnect the PB3 unit from the
DVMRe and hook-up the cable as follows:
The RJ45 end connects to the outside receptacle
of Port 1 of the PB3 unit and the DB9 end
connects to your PC’s COM Port (typically
COM1).
IMPORTANT: If you program the ProBridge via
HyperTerminal you must BACKUP (Save) the
program information via the BACKUP option so that
everytime the unit is powered up, the settings you
configured will be used.
NOTE