Gaggenau KG 291 CA - Manual (Page 11)

10
Switching on
•
Place a suitable pot or a pan on the corresponding
cooking position.
• Press down the control knob for the corresponding
cooking position and turn it to the required
position between the
and symbols. The burner
ignites automatically.
• When using large pots or pans you should ignite
the burner in the low position.
• Every time the gas hob is switched on, the
electronics run an auto test. All electrodes fire
and the required burner ignites after a few
seconds. When switching on further burners, only
the corresponding electrode fires.
• When being switched on, a short sound may be
heard when the electronic of the gas hob opens
the gas supply valve. This is a normal condition.
The flame size can be set continuously between full
and low by slowly turning the control knob.
Indicator light
The indicator light next to the control knob comes
on, if the burner is switched on and the flame burns
correctly.
Should the flame go out during operation (e.g.
because of a draught), the appliance will
automatically re-ignite the burner.
Should the re-ignition be unsuccessful (e.g. burner
is soiled by spilled over food or liquid), all burners
are switched off, the indicator lights of the burners
that were switched on flash. Turn all control knobs
to the OFF position. The flashing indicator lights will
go out except for the affected burner. This indicator
will continue to flash for a few seconds. After the
6. Operation
Only light a burner if all burner parts are dry, and
assembled correctly. Otherwise, malfunctions may
occur or the appliance may switch off.