Gaggenau KG 291 CA - Manual (Page 23)

Important Notes
Please observe the general safety notes and the
important information in chapter 1 and 2.
The appliance must be installed and connected by
an authorised specialist before operation. Before
operating the appliance for the first time, make
sure that the power and gas supply connection are
in proper working order.
The installing technician is responsible for perfect
functioning of the appliance at its installation
location.
He must show the user how to switch off the
electricity and gas supply whenever required.
Caution:
before connecting the appliance, please check
whether the local connection conditions such
as gas type, gas pressure and mains voltage
match the appliance settings.
This gas hob
conforms to the categories that are specified on the
rating plate. The rating plate can be found on the
appliance and additionally on the quality control
slip which is included with these instructions. By
replacing nozzles, it is possible to set the appliance
to any gas listed on the rating plate.
If the data should not match, the appliance must
be changed over to the required gas type and the
available pressure.
As this gas hob is not intended for connection to an
exhaust gas system, pay attention to the applicable
installation conditions.
The appliance may be installed in kitchen
combinations made of wood or similar combustible
materials without taking additional measures. The
rear wall must consist of non-combustible material.
The minimum distances as described on page 23
must be observed.
The hob conforms to appliance class 3 and must be
installed in the countertop as shown in the
installation sketch.
We strongly recommend installation of a hood of at
least 36 ´ ´ / 900 mm width above the cooktop. The
minimum distance from the cooktop to the bottom
edge of the wall hood is 30 ´ ´ / 762 mm.
When using more than 2 rings at the same
time, please operate the extractor hood at
level 2 or higher. This prevents a build-up of
heat in the extractor hood.
W all trims must be heat-resistant, and the minimum
distance between the hob and the wall trim is at
least 1
9 /
16
´ ´ (40 mm).
Remove the packaging from the appliance and
dispose of it according to local regulations. Be
careful to remove all accessories from the
packaging. Keep packaging elements and plastic
bags away from children.
Check the appliance for transport damage before
installing it.
T echnical modifications reserved.
22
14. Installation Instructions