Genie QuietLift 3563435770 - Manual (Page 8)

8
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
P
ROGRAMMING
R
EMOTE
C
ONTROLS
Figure 1 Learn Code Button and Indicator Light
M
AINTENANCE AND
A
DJUSTMENTS
Step 2:
WARNING
A moving garage door may cause serious injury or death.
· Keep people clear of opening while door is moving.
· Do not allow children to play with Remote Controls.
If the Safety Reverse does not work properly:
· Close the door and disconnect the Opener using
the Emergency Release Cord.
· Do not use the door Opener, Remote Controls, or
Wireless Keypad.
· Refer to the door and door Opener Owner’s
Manuals before attempting any repairs.
· Stay clear of the opener's belt, the door and any
other moving parts when operating the opener
with a remote control.
A To Program one Button of a Remote Control
•
Locate Learn Button and Learn Indicator Light on side of
Power Head (
Figure 1).
• Press and release Learn Button. Red Learn Indicator Light will
blink 2 times per second.
• Press Remote Control Button once within 30
seconds(Figures 2 and 3). Red Learn Indicator Light will
stay lit.
• Press Remote Control Button again. Red Learn Indicator Light
will go out, indicating that memory is stored.
B Program each additional Remote using step A above.
NOTE
Only one remote button can be entered at a time. Repeat
A and B for each remote button to be programmed.
1 Button Compact Remote
w/Docking Station
Figure 2 Genie Remote Controls
3 Button Compact Remote
w/Docking Station
Frequency
Switch
Frequency
Switch
315 Mhz
390 Mhz
Figure 5 observe bullet travel
Figure 4 Disengage carriage
B Check the reverse function.
•
Check that the Carriage is disengaged (Figure 4).
• Press the wall button to move the bullet (Figure 5) to the
open position (away from the door) (Figure 4).
–
Observe the belt as it travels and adjust tension
if necessary.
• Press the wall button to start the bullet in the close direction.
• Block the Safe-T-Beam® while the bullet is moving toward
the door (Figure 6).
–
The bullet must stop and reverse direction when the
beam is blocked.
C Check the forced closure feature (Figure 7).
•
Block the Safe-T-Beam®.
• Press the wall button and verify that the bullet moves in
the close direction as long as you hold the button but
reverses whenever you let go of the button (
Figure 7).
WARNING
Be sure the carriage is disengaged from the belt before
performing the following portion of the Safety-T-Beam®
testing. The carriage is disengaged when the release
lever is pointing down ( Figure 4).
Figure 6 Block the beam
Figure 7 Block the beam
PLACE AN OBJECT IN
THE BEAM’S PATH.
BLOCK THE BEAM
WHILE THE BULLET
IS MOVING DOWN.