GE PROFILE PERFORMANCE SERIES PNSF39Z01 - Manual (Page 25)

25
Problem Possible Causes What To Do
Salty tasting water Insufficient backwash and •Increase backwash time. See the Service: Regeneration
after installation rinse time and Heavy Duty Backwash section.
Low water pressure •Check pressure; should be minimum 20 psi.
Restricted drain hose •Clean and reconnect hose.
Resin beads showing Cracked distributor •Call for service.
up in drinking water
and sink
Sounds you might hear Running water from the unit into •This is normal.
a drain
Water has air bubbles Air in system after installation •Will go away after it runs for a while.
and is cloudy
Error Code on control Wiring may have worked loose in •Unplug transformer.
control
•Remove control cover, release clips on side.
•Check for loose/incorrect wiring connections to electronic
board or switch. Reconnect as required.
•Reassemble control cover.
•Plug in Transformer.
•Wait six minutes for Error Code to reappear.
•If Error Code reappears call for service.