GE MULTILINK 1601-9026-A3 - Manual (Page 41)

QUICKSTART GUIDE
MULTILINK ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE 37
Z Select Run then enter CMD to start the DOS shell.
Once the DOS shell has launched, you will be presented with a DOS window.
Z At the DOS prompt enter the command ipconfig followed by the
Enter key.
This is the command that will cause the Ethernet adaptor to immediately use the IP, and
Subnet Mask addresses just programmed. An on-screen report will appear indicating
which addresses are now being used by the adapter. The computer’s configuration is
complete.
Addresses now being used