GE JGP990 - Manual (Page 10)

To Remove the Grill Module:
1. Make sure that all control knobs are
set to OFF and all grill components
are cool.
2. Remove the grill grate.
3. Lift the grill burner up slightly and
pull it away from the white slotted
receptacle and brass orifices. Lift it out
of the basin when it is completely
unplugged.
4. Do not store or stack modules where
they could fall or be damaged.
NOTE: The optional sealed burner
module JXGB90 can replace the grill
burner assembly.
Surface burner and grill modules.
Throughout this manual, features and appearance may vary from your model.
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
10
Sealed Burner Module
To Install the Sealed Burner Module:
1. Make sure that all control knobs are
set to OFF.
2. Clean the cooktop basin to remove
any grease accumulation. See the Care
and Cleaning the Cooktop section.
3. With the back of the burner module
tilted up and the two round openings
and three pins facing toward the front,
insert the module in the cooktop basin.
4. Slide the burner module forward until
the pins start to engage the white
slotted receptacle.
5. Lower the back of the module into
place and carefully slide it forward
until the pins are fully engaged.
6. Place the burner caps on the burners.
Carefully place the grate onto the
module with the two tabs on the
underside toward the center of
the cooktop.
To Remove the Sealed Burner Module:
1. Make sure that all control knobs are
set to OFF and that the cooktop is cool.
2. Lift up the edge of the burner module
until the bottom of the module clears
the edge of the basin.
IMPORTANT: Do not lift the module too
high while it is still connected—you could
damage the ignitor rods and mixer tubes.
3. Hold the module by the sides and pull
it away from the slotted receptacle and
brass orifices. Lift it out of the basin
when it is completely unplugged.
4. Do not store or stack modules where
they could fall or be damaged.
NOTE: The optional sealed burner
module JXGB90 can replace the grill
burner assembly.
Grill Module
To Install the Grill Module:
1. Make sure that all control knobs are
set to OFF.
2. Position the grill burner with the
two round tubes and three pins facing
the front.
3. Slide the grill burner forward until the
pins and ignitors are engaged in the
white slotted receptacle; then lower
the burner until it rests on the
mounting pins.
4. Carefully place the grill grate on the
cooktop. The grate is designed to fit
one way only. See the illustration.
NOTE: Before using the grill for the first time,
heat the grill burner to remove the protective
shipping coating. Heat the grill burner on HI
for 10 minutes and use the vent system to
remove any additional smoke during cooling.
The grill consists of a black grill grate and the grill burner. Only install the grill on the left side
of your cooktop.